UMN:CLI User Manual
V8102
352
9.3.6.4 Class Creation
One class can include several flows. You can simply handle and configure the packets on
several flows at once.
To create a class including more than 2 flows, use the following command.
class admin NAME flow FLOW1
[FLOW2] [FLOW3]
Creates an admin class including at least 2 admin
flows.
NAME: admin class name
FLOW: admin flow name
To delete configured admin class or all admin classes, use the following command.
Deletes all admin classes.
Deletes specified admin class.
NAME: admin class name
no class admin NAME flow
FLOW1 [FLOW2] [FLOW3]
Removes specified admin flows from class.
NAME: admin class name
FLOW: admin flow name
9.3.7 Admin Rule Action
9.3.7.1 Admin Policy Creation
For the V8102, you need to open Admin-Policy Configuration mode first. To open Policy
Configuration mode, use the following command.
Creates an admin policy and opens Admin-Policy Con-
figuration mode.
NAME: admin-policy name.
After opening Admin Policy Configuration mode, the prompt changes from
SWITCH(config)# to SWITCH(config-admin-policy[NAME])#.
To display elete configured admin policy or all admin policies, use the following command.
show policy admin [NAMES]
Shows specified admin policy.
To delete configured admin policy or all admin policies, use the following command.
To Next Page
Loading...