Dasan V8102 - Bandwidth; Maximum Transmission Unit (MTU)

UMN:CLI User Manual
V8102
472
To display the debugging status of PPPoE, use the following command.
Command
Mode
Description
show debug pppoe
Global
Shows the debugging status of PPPoE.
show debugging pppoe
9.16 Bandwidth
Routing protocol uses bandwidth information to measure routing distance value. To con-
figure bandwidth of interface, use the following command.
Command
Mode
Description
bandwidth BANDWIDTH
Interface
Configures bandwidth of interface.
BANDWIDTH:
<1-999> k|m for 1 to 999 kilo bits or mega bits
<1-10> g for 1 to 10 giga bits
no bandwidth BANDWIDTH
Deletes configured bandwidth of interface.
This bandwidth is valid only for forwarding routing information and it does not concern any
physical bandwidth.
9.17 Maximum Transmission Unit (MTU)
Maximum value for the length of the data payload can be transmitted. You can set a max-
imum transmission unit (MTU) with below command.
Command
Mode
Description
mtu <68-9170>
Interface
[XE/GE/GPON]
Sets a MTU size.
no mtu
Returns to the default MTU size.
i