Dasan V8102 - DNS Server

User Manual UMN:CLI
V8102
79
no sntp SERVER1 [SERVER2]
[SERVER3]
Deletes a specified SNTP server.
no sntp
Disables SNTP function.
You can configure up to 3 servers so that you use second and third servers as backup
use in case the first server is down.
To display SNTP configuration, use the following command.
Command
Mode
Description
show sntp
Enable
Global
Show SNTP configuration.
4.1.6 DNS Server
To set a DNS server, use the following command.
Command
Mode
Description
dns server {A.B.C.D | X:X::X:X}
Global
Sets a DNS server.
A.B.C.D: DNS server IPv4 address
X:X::X:X: DNS server IPv6 address
no dns server {A.B.C.D |
X:X::X:X}
Removes a DNS server.
To display a configured DNS server, use the following command.
Command
Mode
Description
show dns
Enable
Global
Shows a configured DNS server.
If a specific domain name is registered instead of IP address, user can do telnet, FTP,
TFTP and ping to the hosts on the domain with domain name.
To search domain name, use the following command.
Command
Mode
Description
dns search DOMAIN
Global
Searches a domain name.
no dns search DOMAIN
Removes a domain name.
It is possible to delete DNS server and domain name at the same time with the below
command.
Command
Mode
Description
no dns
Global
Deletes DNS server and domain name.
i