Dasan V8102 - Interface Alias Name; Interface Identifier

User Manual UMN:CLI
V8102
93
Command
Mode
Description
show interface-status [{gigabitethernet |
tengigabitethernet | gpon | channelgroup}
IFPORTS]
Enable
Global
Interface
Shows a current port status, enter a port
number.
PORTS: port number (1/1, 1/2, 2/1, …)
show interface status [{gigabitethernet |
tengigabitethernet | gpon | channelgroup}
IFPORTS]
show interface description
Shows the description of an interface.
show interface module-info [{gigabitethernet |
tengigabitethernet | gpon | channelgroup}
IFPORTS]
Shows optical module (SFP) information.
5.4.6 Interface Identifier
To specify a identifier on an interface, use the following command.
Command
Mode
Description
identifier hex LINE
Interface
Sets interface identifier.
LINE: Interface identifier of max 8byte value (e.g.
ffeac3c434f20a00)
5.4.7 Interface Alias Name
To set alias name for interface, use the following command.
Command
Mode
Description
alias WORD
Interface
Sets alias name of the interface.
WORD: name