Dasan V8102 - ICMP Destination Unreachable Message

User Manual UMN:CLI
V8102
231
To configure the limited ICMP transmission time, use the following command.
Command
Mode
Description
ip icmp interval rate-limit IN-
TERVAL
Global
Configures a limited ICMP transmission time.
INTERVAL: 0-2000000000 (unit: 10 ms)
The default ICMP interval is 1 second (100 ms).
To return to default ICMP configuration, use the following command.
Command
Mode
Description
ip icmp interval default
Global
Returns to default configuration.
To display ICMP interval configuration, use the following command.
Command
Mode
Description
show ip icmp interval
Enable
Global
Shows ICMP interval configuration.
7.15.3 ICMP Destination Unreachable Message
If the switch receives a packet that has an unknown protocol or no route to the destination
address, the switch sends an ICMP unreachable message to its source address. To ena-
ble/disable generation of ICMP unreachable messages, use the following command.
Command
Mode
Description
ip unreachables
Interface
[VLAN]
Enables sending ICMP unreachable messages on the
interface. (default)
no ip unreachables
Disables sending ICMP unreachable messages on the
interface.
i