Dasan V8102 - Rule Configuration Mode; RMON Configuration Mode; Tab. 3.6 Main Command of DHCP Option 82 Configuration Mode; Tab. 3.7 Main Command of Rule Configuration Mode

UMN:CLI User Manual
V8102
56
Global Configuration mode first!
Tab. 3.6 is the main commands of DHCP Option 82 Configuration mode.
Command
Description
policy
Configures the policy for option 82 field in the DHCP packet.
system-remote-id
Configures a system remote ID.
system-circuit-id
Configures a system circuit ID.
Tab. 3.6 Main Command of DHCP Option 82 Configuration Mode
3.1.8 Rule Configuration Mode
Rule configuration is classified by three different modes according to its roles for Rule
mechanism. You can configure a rule for incoming or outgoing packets. Using the function,
you can handle packets classified by the rule.
To open Rule Configuration mode, enter the flow, policer and policy commands, then
the system prompt will be changed from SWITCH(config)# to SWITCH(config-
flow[NAME])#, SWITCH(config-policer[NAME])# and SWITCH(config-policy[NAME])# .
Command
Mode
Description
flow NAME create
Global
Opens Flow Configuration mode.
policer NAME create
Opens Policer Configuration mode.
policy NAME create
Opens Policy Configuration mode.
Tab.3.7 shows main commands of Rule Configuration mode.
Command
Description
cos
Classifies an IEEE 802.1p priority.
mac
Classifies a MAC address.
action match
Configures a rule action for classified packets.
rate-limit
Comfigures a rate-limit of classified packets
priority
Configures a rule priority of specified policy.
Tab. 3.7 Main Command of Rule Configuration Mode
3.1.9 RMON Configuration Mode
In RMON Configuration mode, you can configure RMON alarm, RMON event and RMON
history. The V8102 provides three different configuration modes to configure each type of
RMON.
Command
Mode
Description
rmon-alarm <1-65535>
Global
Opens RMON Configuration mode.
1-65535: index number
rmon-event <1-65535>
rmon-history <1-65535>