UMN:CLI User Manual
V8102
876
no r-bit-transmit-set-policy
Deletes the configured R-bit transmit set policy.
To configure the R-bit receive policy, use the following command.
r-bit-receive-policy {none | play-
out | send-idle}
Defines the action toward the N x 64 TDM interface
when remote failure is indicated on packets received
from the PSN (R-bit set = 0b10 while the L-bit is
cleared).
none: Do nothing (default)
play-out: Play out service-specific RAI/REI/RDI code
send-idle: Send channel idle signalling and idle chan-
nel payload to all DS0s comprising the service
13.9.7 SES Threshold
To configure the SES threshold, use the following command.
Defines the number of lost, malformed or otherwise
unusable packets expected in the PSN to TDM direc-
tion within a one-second interval that causes a severely
errored second to be counted. Stray packets do not
count toward a severely errored second, nor do pack-
ets whose L-bit is set at the far end.
VALUE: Number of lost, malformed or otherwise unus-
able packets (default: 3)
Deletes the configured SES threshold.
13.9.8 Saving Pseudowire Maintenance Profile
After configuring a pseudowire maintenance profile, you need to save the profile with the
following command.
Saves a pseudowire maintenance profile configuration.
Whenever you modify a pseudowire maintenance profile, you should apply the changes
again using the apply command. If not, the changes will not be applied.
To Next Page
Loading...