UMN:CLI User Manual
V8102
696
12.3.12 Summary Routing Information
You can use not-advertise option command to block routes that match the specified pre-
fix/length pair. Or use the specific tag value that can be used a “match” value for control-
ling redistribution using route maps.
To create aggregate addresses for the OSPFv3 protocol, use the following command.
summary-address X:X::X:X/M
Creates the aggregate addresses for OSPFv3.
summary-address X:X::X:X/M
not-advertise
Blocks routes that match the specified prefix/length
pair.
summary-address X:X::X:X/M
tag <0-4294967295>
Configures the summary routing information with a
specific tag
To delete the specified aggregate addresses for the OSPFv3, use the following command.
no summary-address X:X::X:X/M
Deletes the specified aggregate addresses
no summary-address X:X::X:X/M
{not-advertise | tag <0-
4294967295>}
12.3.13 Finding Period
OSFP start to find the shortest path as soon as got a notification of changing the network
component. You can configure the period to find the path. To configure the period of find-
ing, use the following command.
timers spf SPF-DELAY SPF-
HOLD
Configures the period of finding in the unit of second.
SPF-DELAY: 0-2147483647 (defaut: 5000, 5 secs)
SPF-HOLD: 0-2147483647
timers spf exp SPF-MINIMUM
SPF-MAXIMUM
Configures the period using the exponential backoff
delays.
SPF-MINIMUM: 0-2147483647 (defaut: 5000, 5 secs)
SPF-MAXIMUM: 0-2147483647
To release the configuration, use the following command.
Release the configuration.
To Next Page
Loading...