User Manual UMN:CLI
V8102
49
3 Command Line Interface (CLI)
The V8102 enables system administrators to manage the V8102 by providing the com-
mand line interface (CLI). This user-friendly CLI provides you with a more convenient
management environment.
To manage the system with the CLI, a management network environment is required. The
V8102 can connect to the management network either directly (outband) or through the
access network (inband). It can even connect using a combination of the two; for example,
a cascaded V8102 connects inband to the cascading switch, and then from the cascading
switch to the management network through the outband interface.
The V8102 also provides the RS232 console interface to simply access the system with a
provided RJ45-to-DB9 cable.
This chapter describes a basic instruction for using the command line interface (CLI)
which is used for managing the V8102 system.
• Configuration Mode
• Useful Tips
3.1 Configuration Mode
You can configure and manage the V8102 with the CLI via a management network envi-
ronment or the console interface.
The CLI provides the following command modes:
• Privileged EXEC View Mode
• Privileged EXEC Enable Mode
• Global Configuration Mode
• DHCP Pool Configuration Mode
• DHCP Option Configuration Mode
• DHCP Option 82 Configuration Mode
• Interface Configuration Mode
• Rule Configuration Mode
• RMON Configuration Mode
• Router Configuration Mode
• Route-Map Configuration Mode
• GPON Configuration Mode
To Next Page
Loading...