Dasan V8102 - Channel Group Mode; DHCP Pool Configuration Mode; IP Tunnel Configuration Mode

UMN:CLI User Manual
V8102
54
When a VLAN ID is created in the VLAN Database mode, you can enter the VLAN Inter-
face mode. To open VLAN Interface mode, enter the interface vlan command, then the
system prompt will be changed from SWITCH(config)# to SWITCH(config-if[VLANS])#.
Command
Mode
Description
interface vlan VLANS
Global
Opens VLAN Interface mode.
VLANS: an existing VLAN ID
3.1.4.5 Channel Group Mode
The Channel Group mode contains commands for configuring Link Aggregation Groups
(LAG) or Trunk.
To open Channel Group mode, enter the interface channelgroup command, then the
system prompt will be changed from SWITCH(config)# to SWITCH(config-if[CG#])#.
Command
Mode
Description
interface channelgroup GROUP-
ID
Global
Opens Channel Group mode.
GROUP-ID: an existing channel-group number
IFPORT-RANGE: list of valid channel-group numbers
to add.
interface range channelgroup
GROUP-ID-RANGE
3.1.4.6 IP Tunnel Configuration Mode
You can create a tunnel interface and then configure the logical interface for your IP tun-
nel.
To open Interface tunnel mode, enter the interface tunnel command, then the system
prompt will be changed from SWITCH(config)# to SWITCH(config-if[tunnel#])#.
Command
Mode
Description
interface tunnl <0-1023>
Global
Interface
Opens Interface tunnel mode.
0-1023: tunnel interface number.
3.1.5 DHCP Pool Configuration Mode
In DHCP Pool Configuration mode, you can configure general functions of DHCP per
each DHCP pool. The V8102 supports multiple DHCP environments with this pool-based
DHCP configuration.
To open DHCP Pool Configuration mode, enter the ip dhcp pool command, then the sys-
tem prompt will be changed from SWITCH(config)# to SWITCH(config-dhcp[POOL])#.
Command
Mode
Description
ip dhcp pool POOL
Global
Opens DHCP Pool Configuration mode to configure
DHCP.