User Manual UMN:CLI
V8102
201
0-7: LMM message priority (default: 7)
ethernet oam lmm meg NAME
mepid <1-8191> multicast [<5-
6000> <100-60000> <1-1000> <0-
7>]
Transmits the frames with multicast ETH-LM infor-
mation.
7.7.14.2 Dual-ended Loss Measurement
To enable/disable each MEP for sending periodic dual-ended frames with ETH-LM infor-
mation to its peer MEP, use the following command.
ethernet oam dlm enable meg NAME mepid <1-
8191> rmepid <1-8191>
Enables a MEP to send dual-ended
frames with ETH-LM information.
ethernet oam dlm disable meg NAME mepid <1-
8191>
Disables a MEP to send dual-ended
frames with ETH-LM information.
Dual-ended LM counts do not include OAM frames at the MEPs ME level.
To display the configuration of dual-ended frame loss measurement, use the following
command.
show ethernet oam dlm [meg NAME [mepid <1-
8191>]]
Shows a configured dual-ended frame
loss measurement.
7.7.15 Ethernet Frame Delay Measurement (ETH-DM)
To measure frame delay and frame delay variation, ETH-DM can be used for OAM. By
sending/receiving periodic frames with ETH-DM information to/from the peer MEP, each
MEP performs frame delay and frame delay variation measurement.
7.7.15.1 One-way ETH-DM
Each MEP sends frame with one-way ETH-DM information to its peer MEP. 1DM PDU is
used to support one-way ETH-DM.
To transmit/receive 1DM frames to/from the peer MEP, use the following command.
ethernet oam 1dm receive meg NAME mepid
<1-8191> [<5-6000>]
Receives 1DM frames from a peer MEP.
1-8191: source MEP ID to receive 1DMs
5-6000: the duration (default: 5 s)
ethernet oam 1dm transmit meg NAME mep-
Transmits 1DM frames with multicast
To Next Page
Loading...