UMN:CLI User Manual
V8102
66
The created password can be displayed with the show running-config command. To en-
crypt the password not to be displayed, use the following command.
service password-encryption
Encrypts the system password.
To disable password encryption, use the following command.
no service password-encryption
Disables password encryption.
4.1.3.2 Changing Login Password
To configure a password for created account, use the following command.
Configures a password for created account.
USER: user’s name to change a password
The following is an example of changing the current password.
SWITCH(config)# passwd
Changing password for admin
Enter the new password (maximum of 32 characters)
Please use a combination of upper and lower case letters and numbers.
Enter new password:junior95
Re-enter new password:junior95
Password changed.
SWITCH(config)#
The password you are entering will not be shown in the screen, so please be careful not
to make a mistake.
4.1.3.3 Login Password Recovery Process
To recovery login password to default, perform the following step-by-step instruction:
Step 1
After the V8102 is manually restarted, the booting messages are shown up. Keep on
pressing [Space Bar] key right after “[Loading OS1 image ...]” is shown up on the screen.
Step 2
Enter “password” and press [Enter] key when displaying a blinking cursor after “[Image
OK OS1]”
Step 3
Verify the “password restore to default...” messages.
To Next Page
Loading...