Dasan V8102 - Fault Alarm Detection; OAM on Trunk Port; Sender ID TLV

User Manual UMN:CLI
V8102
189
Command
Mode
Description
ethernet oam mep disable meg
NAME [mepid <1-8191>]
Global
Disables Y.1731 OAM for MEPs
7.7.4 Fault Alarm Detection
To configure parameters for detecting and notifying its faults, use the following command.
Command
Mode
Description
ethernet oam fault-detect meg
NAME [mepid <1-8191>] {priority
<1-8> | keep-time <0-1023> |
clear-time <0-1023>}
Global
Specifies a value of each parameter for detecting and
notifying its faults.
NAME: MEG’s name
1-8: priority for notifying the faults (default: 2)
0-1023: the time for the operation to verify the detected
faults. (default: 250=2.5seconds)
0-1023: the time for the operation to verify the deleted
faults. (default: 1000=10 seconds)
no ethernet oam fault-detect
meg NAME [mepid <1-8191>]
{priority | keep-time | clear-time}
Deletes a specified value of parameters and returns to
the default setting.
7.7.5 Y.1731 OAM on Trunk Port
Enable/disable ITU-T Y.1731 OAM on the trunk port, use the following command.
Command
Mode
Description
ethernet oam trunk PORT meg
NAME
Global
Enables Y.1731 OAM on a trunk port.
PORT: a port number of bridge
NAME: MEG’s name
no ethernet oam trunk PORT
Disables Y.1731 OAM on a trunk port.
PORT: a port number of bridge
7.7.6 Sender ID TLV
To add/delete the sender ID TLV to OAM PDUs, use the following command.
Command
Mode
Description
ethernet oam tlv-permission
sender-id
Global
Adds the sender ID TLV to OAM PDUs.
no ethernet oam tlv-permission
sender-id
Deletes the sender ID TLV.