User Manual UMN:CLI
V8102
87
ly operated.
Step 1 Configure a slot for the specified IU type, use the following command.
slot planning iu SLOT_NUMBER {siu-gpon16 |
sfu-10ge4}
Specifies an IU type in a slot.
SLOT_NUMBER : the slot number of IU
(e.g. X | X-Y)
If a slot was configured with a specified IU type, and the system has detected that a dif-
ferent type of IU is physically inserted in this slot, the equipped IU cannot be activated in
the system.
Step 2 Change the admin state to ‘unlock’ for each slot to activate the equipped IU.
slot unlock iu SLOT_NUMBER
Unlocks a particular slot.
SLOT_NUMBER : the slot number of IU (e.g. X | X-Y)
To lock a particular slot for preventing the abnormal operation, use the following com-
mand.
Locks a particular slot. (default)
SLOT_NUMBER : the slot number of IU (e.g. X | X-Y)
5.2.2 IUs Replacement
The procedures in this section replace IU to another one. The configuration of IU’s re-
placement is a five-step process:
Step 1 Lock the existing IU in a slot that you want to replace.
To lock a particular slot, use the following command.
Locks a particular slot. (default)
SLOT_NUMBER : the number of IU slot (e.g. X | X-Y)
Step 2 Remove the existing IU from the slot, use the following command.
no slot planning iu SLOT_NUMBER
Removes the registered IU from the
slot.
To Next Page
Loading...