User Manual UMN:CLI
V8102
677
Shows all the debugging information.
debug ospf events [abr | asbr |
lsa | nssa | os | router | vlink]
Shows information about OSPF operation such as
OSPF neighbor router, transmitted information, decid-
ing destination router, calculating the shortest route,
and so on.
debug ospf {ifsm | nfsm | nsm}
[{events | status | timers}]
Shows the debugging information of OSPF interface.
debug ospf lsa [flooding | gen-
erate | refresh]
Shows information transmitted by OSPF and calculat-
ing the shortest route.
debug ospf packet {hello | dd |
ls-ack | ls-request | ls-update |
all} [send | recv [detail]]
Shows the debugging information of each packet.
debug ospf route [ase | ia | in-
stall | spf]
Shows the debugging information of OSPF routing.
To display the debugging information, use the following command.
Shows the debugging information of OSPF.
12.2.19.3 Sending SNMP Trap
To enable/disable the system to send SNMP trap message of OSPF routing information,
use the following command.
ospf snmp-notification enable
Configures the system to send SNMP trap of routing
information while OSPF is running.
ospf snmp-notification disable
Disables the system to send SNMP trap of routing
information while OSPF is running.
12.2.19.4 Logging Neighbor Changes
To enable/disable the system to log changes in OSFP neighbors’ state such as system
up/down and reset, use the following command.
ospf log-neighbor-changes
Enables logging of OSPF neighbor state changes
no ospf log-neighbor-changes
Disables logging of OSPF neighbor state changes
12.2.19.5 Limiting Number of Database
The V8102 can limit the Number of Database to process in OSPF. For example, if a rout-
er connected with many of routers, it carries overload to process the database. Therefore,
Limiting the Number of Database reduces the overload on system.
To Next Page
Loading...