UMN:CLI User Manual
V8102
82
SWITCH# where
admin at ttys0 from console for 4 days 22 hours 15 minutes 34.88 seconds
admin at ttyp1 from 147.54.140.133:49538 for 6 minutes 44.12 seconds
SWITCH#
4.2 System Configuration Management
4.2.1 Displaying System Configuration
To display the current running configuration of the system, use the following command.
Shows a configuration of the system.
show running-config {access-list | admin-flow |
admin-policy | arp | as-path access-list | bgp |
community-list | dhcp | dhcp6 | dns | flow [NAME]
| full | hostname | ip mroute | ip multicast | key
chain | ip route | login | policer | policy | ip | ipv6 |
pppoe | router | rmon-alarm | rmon-event | rmon-
history | route-map | router {bgp | rip | ospf } |
router ipv6 {ospf| rip} | router-id | snmp | syslog |
time-zone} | multicast-access-list [NAME] | mul-
ticast-profile [NAME] | nd | pm-profile [NAME] |
pppoe | prefix-list | rate-limit-profile [name] |
slowpath-filter}
Shows a configuration of the system
with the specific option.
show running-config interface {management |
vlan VLANS | loopback | gigabitethernet IFPORT |
tengigabitethernet IFPORT | gpon IFPORT |
channelgroup GROUP | tunnel }
show running-config interface {management |
vlan VLANS | loopback | gigabitethernet IFPORT |
tengigabitethernet IFPORT | gpon IFPORT |
channelgroup GROUP} ip {igmp | multicast}
show running-config interface {management |
vlan VLANS | loopback | gigabitethernet IFPORT |
tengigabitethernet IFPORT | gpon IFPORT |
channelgroup GROUP} ipv6 {ospf | pim {dense-
mode | sparse-mode} | rip}
show running-config { gpon | dba-profile [NAME]|
onu-profile [NAME] | extended-vlan-tagging-
operation [NAME] | tdm-pw-profile [NAME] | traf-
fic-profile [NAME]| voip-profile [NAME]| pw-
maintenance-profile[NAME]}
Shows the configurations of the sys-
tem with the GPON option.
4.2.2 Comparing Configuration Changes
To display the different configuration between startup-config and running-config, use the
following command.
To Next Page
Loading...