Dasan V8102 - Syslog Bind Address; Debug Message for Remote Terminal; Disabling Syslog; Displaying Syslog Message

UMN:CLI User Manual
V8102
176
7.4.4 Syslog Bind Address
You can specify an IP address to attach to the syslog message for its identity. To specify
the IP address to bind to a syslog message, use the following command.
Command
Mode
Description
syslog bind-address A.B.C.D
Global
Specifies the IP address to bind to a syslog message.
no syslog bind-address
Deletes a specified IP address.
7.4.5 Debug Message for Remote Terminal
To display a syslog debug message to a remote terminal, use the following command.
Command
Mode
Description
terminal monitor
Enable
Enables the terminal monitor function.
no terminal monitor
Disables the terminal monitor function.
This function is not operational in the local console.
7.4.6 Disabling Syslog
To disable the syslog, use the following command.
Command
Mode
Description
no syslog
Global
Disables the syslog.
The syslog is enabled by default.
7.4.7 Displaying Syslog Message
To display the received syslog message in the system memory, use the following com-
mand.
Command
Mode
Description
show syslog local {volatile |
non-volatile} [NUMBER]
Enable
Global
Shows the received syslog messages.
volatile: removes the syslog messages after restart.
non-volatile: reserves the syslog messages.
NUMBER: shows the last N syslog messages.
show syslog local {volatile |
non-volatile} reverse
Shows the received syslog messages in the reverse
order.
show syslog external sdcard
slot SLOT_NUMBER [file FILE-
NAME] [<1-4294967295> | re-
Shows the received syslog messages from external
output file.
i
i