Dasan V8102 - Link Type; Displaying Configuration

UMN:CLI User Manual
V8102
378
9.4.6.4 Link Type
A port that operates in full-duplex is assumed to be point-to-point link type, while a half-
duplex is considered as a shared port. .
To configure the link type of port, use the following command.
Command
Mode
Description
spanning-tree link-type {point-
to-point | shared}
Interface
[XE/GE]
Specifies a link-type for a designated port
point-to-point: full-duplex
shared: half-duplex
To delete a configured link type of port, use the following command.
Command
Mode
Description
no spanning-tree link-type
Interface
[XE/GE]
Deletes a configured link type.
9.4.6.5 Displaying Configuration
To display the configurations of STP, use the following command.
Command
Mode
Description
show spanning-tree
Enable
Global
Shows all configurations of STP
show spanning-tree active [detail]
Global
Shows STP information on active inter-
face:
detail: detailed STP information (as
option).
show spanning-tree blockedif
Shows information of the blocked ports
show spanning-tree detail [active]
Shows detailed information of STP.
show spanning-tree inconsistentports
Shows information of root-inconsistency
state.
show spanning-tree bridge { address | detail |
forward-time | hello-time | id | max-age | proto-
col | priority [system-id] }
Shows information of the bridge status
and configuration
show spanning-tree root { address | cost |
detail | forward-time | hello-time | id | max-age |
port | priority [system-id] }
Shows the status and configuration for
the root bridge.
show spanning-tree interface IFPORTS [ active
[detail] | cost | detail [active] | edgeport | incon-
sistency | rootcost | state | priority ]
Shows STP information of specified
port.
show spanning-tree summary [totals]
Shows a summary of STP:
totals: the total lines of STP