Dasan V8102 - IGMP Configurations

User Manual UMN:CLI
V8102
883
13.11.2 IGMP Configurations
To configure the multicast profile, use the following command.
Command
Mode
Description
igmp version <1-3>
Multicast-
Profile
Sets an IGMP version on a current interface.
1-3: IGMP version (default: 2)
igmp function snooping
Enables the IGMP snooping.
igmp function suppression
Enables the IGMP snooping with proxy reporting
(SRP).
igmp function proxy
Enables the IGMP proxy.
igmp immediate-leave enable
Enables the IGMP immediate leave. (Default: enable)
igmp querier address A.B.C.D
Specifies a querier address.
A.B.C.D: querier address
igmp querier query-interval <0-
3600>
Specifies a general query interval.
0-3600: query interval (default: 125 seconds)
igmp querier max-response-time
<0-25>
Specifies a maximum query response time.
0-25: maximum response time (default: 10 seconds)
igmp robustness-variable <1-7>
Configures the Querier’s Robustness Variable (QRV)
value on an interface. (default: 2)
igmp access-list vid {untagged |
VLAN} dst-ip start A.B.C.D end
A.B.C.D [bw VALUE | src-ip
A.B.C.D | gem PORT | cos <0-7>]
Configures the dynamic/static access control list table.
It discards the IGMP join message from ONTs based
on the access list.
VLAN: 1 to 4095, VLAN ID for specific tagged down-
stream flow
dst-ip: destination IP address
A.B.C.D: start/end IP address of the multicast group
range
VALUE: imputed group bandwidth (unit: bytes/sec)
src-ip: source IP address
PORT: multicast GEM port ID
igmp static-access-list vid {un-
tagged | VLAN} dst-ip start
A.B.C.D end A.B.C.D [bw VALUE
| src-ip A.B.C.D | gem PORT |
cos <0-7>]
igmp tag-control {bypass | add
vid VLANS cos VALUE | replace
vid VLANS [cos VALUE]}
Configures IGMP tag control attribute and the policy to
define a VLAN ID and P-bits to add to upstream IGMP
messages.
bypass: pass upstream IGMP traffic transparently
add: adds a VLAN tag (including P-bits) to upstream
IGMP traffic
replace: replaces the TCI (VLAN ID + P-bits or VLAN
ID)
VLANS: VLAN ID(s) (1-4095)
VALUE: CoS (0-7)
igmp ds-tag-control {remove |
bypass | add vid VLANS cos
VALUE | replace vid VLANS [cos
VALUE]}
Configures IGMP downstream tag control attribute and
the policy to define a VLAN ID and COS value to add
to IGMP messages.
bypass: pass downstream IGMP traffic transparently
add: adds a VLAN tag (including P-bits) to downstream
IGMP traffic
replace: replaces the TCI (VLAN ID + P-bits or VLAN
ID)