UMN:CLI User Manual
V8102
338
Shows a collected policy counter.
9.3.3.3 Rate-limit
You can configure the rate limit in kbps unit for the classified packets and control the
bandwidth. To set the bandwidth of classified packets in specified policer, use the follow-
ing command.
Sets the bandwidth for classified packets belonging to
specified policer (unit: kbps)
Deletes the configured bandwidth for classified packets
of specified policer.
9.3.3.4 Applying and modifying Policer
After configuring a policer using the above commands, apply it to the system with the fol-
lowing command. If you do not apply the policer to the system, all specified configurations
on Policer Configuration mode will be lost.
To save and apply a policer, use the following command.
Applies a policer to the system.
To modify a policer, use the following command.
Modifies a policer, enter a policer name.
9.3.4 Rule Action
9.3.4.1 Policy Creation
To configure a policy, you need to open Policy Configuration mode first. To open Policy
Configuration mode, use the following command.
Creates a policy and opens Policy Configuration mode.
NAME: policy name.
After opening Policy Configuration mode, the prompt changes from SWITCH(config)# to
SWITCH(config-policy[NAME])#.
To delete configured policy or all policies, use the following command.
Deletes a policy, enter a policy name.
To Next Page
Loading...