Dasan V8102 - Enabling STP Function; STP Mode

User Manual UMN:CLI
V8102
375
9.4.4 Enabling STP Function
First of all, you need to enable STP function. You cannot configure any parameters relat-
ed to Spanning Tree Protocol without this command.
To enable STP function on the V8102, use the following command.
Command
Mode
Description
spanning-tree
Global
Enables STP function.
To disable STP function from the system, use the following command.
Command
Mode
Description
no spanning-tree
Global
Disables STP function.
To enable STP function on a interface, use the following commane.
Command
Mode
Description
spanning-tree enable
Interface
[XE/VLAN/CG]
Enables STP function per the interface.
To disable STP function from the interface, use the following command.
Command
Mode
Description
spanning-tree disable
Interface
[XE/VLAN/CG]
Disables STP function per interface.
9.4.5 STP Mode
To select the spanning tree mode, use the following command.
Command
Mode
Description
spanning-tree mode { mst | rstp |
stp | rapid-pvst | rapid-pvst+}
Global
Configures a spanning-tree mode:
mst: Multiple Spanning Tree Protocol (default)
rapid-pvst: Per-vlan Rapid STP
To delete the configured spanning tree mode, use the following command.
Command
Mode
Description
no spanning-tree mode
Global
Deleted a configured spanning tree mode. (default:
MSTP)