Dasan V8102 - Syslog Index

User Manual UMN:CLI
V8102
175
no syslog local-code
Deletes a specified facility code.
The following is an example of configuring priority of all syslog messages which is trans-
mitted to remote host 10.1.1.1, as the facility code 0.
SWITCH(config)# syslog output err remote 10.1.1.1
SWITCH(config)# syslog local-code 0
SWITCH(config)# show syslog
System logger on running!
info local volatile
info local non-volatile
err remote 10.1.1.1
local_code 0
SWITCH(config)#
7.4.3 Syslog index
To set a user-defined syslog message index level with a priority, use the following com-
mand.
Command
Mode
Description
syslog index {system | physical-
entity | dhcp | filter | rmon | gpon
| loop-detect | snmp} INDEX
priority {emerg | alert | crit | err |
warning | notice | info | debug}
Global
Generates a user-defined syslog message index with a
priority
no syslog index {system |
physical-entity | dhcp | filter |
rmon | gpon | loop-detect }
INDEX
Deletes a specified user-defined syslog message index
level with a priority.
To display the configuration of the syslog index, use the following command.
Command
Mode
Description
show syslog index
Enable
Global
Shows the information of syslog message index
show syslog index {system |
physical-entity | dhcp | filter |
rmon | gpon | loop-detect}
[INDEX]
Shows the syslog index information of each parameter
The order of priority is emergency > alert > critical > error > warning > notice > info >
debug. If you set a specific level of syslog output, you will receive only a syslog message
for selected level or higher. If you want receive a syslog message for all the levels, you
need to set the level to debug.
i