UMN:CLI User Manual
V8102
346
priority {low | medium | high-
middle | high | highest}
Sets a priority for a policy. (default: medium)
9.3.4.4 Policy Action
To specify the rule action for the packets matching configured classifying patterns, use the
following command.
Denies the classified packets.
Permits the classified packets.
Sends a copy of classified packets to mirror monitoring
port.
Specifies a VLAN ID of classified packets.
VLANS: VLAN ID (1-4094)
Sends a copy of classified packets to CPU.
action match cancel-copy-to-
cpu
Cancels the copying packet to CPU.
action match donot-copy-to-cpu
Do not send a coppy of classified packets to CPU.
action match cpu-cos <0-7>
action match donot-remark-cos
Do not change 802.1p CoS field in the packet.
action match dmac MAC-ADDR
Specifies the destination MAC address of classified
packets.
Sets different server field.
0-63: DiffServ field value
action match route next-hop
A.B.C.D [A.B.C.D] [A.B.C.D] [veri-
fy-reachability]
Specifies next-hop address of classified packets.
A.B.C.D: IP address of next hop
[A.B.C.D]: Secondary , third IP address.
action match route next-hop6
X:X::X:X [X:X::X:X] [verify-
reachability]
Specifies next-hop6 address of classified packets.
X:X::X:X: IPv6 address of next hop
To delete a specified rule action, use the following command.
Deletes a specified rule action.
no action match copy-to-cpu
no action match cancel-copyto-cpu
no action match donot-copy-to-cpu
no action match donot-remark-cos