Dasan V8102 - Ethernet Alarm Indication Signal (ETH-AIS)

UMN:CLI User Manual
V8102
196
7.7.11 Ethernet Alarm Indication Signal (ETH-AIS)
ITU-T Y.1731 supports fault notification through Alarm Indication Signal (AIS). Ethernet
AIS is used to suppress alarms following detection of defect conditions at the server layer.
ETH-AIS implementation of the V8102 has the following restriction, so you should keep in
mind that before configuring ETH-AIS.
• ETH-AIS function can not be enabled with STP. When STP is already enabled in the
system, ETH-AIS function can not be enabled.
7.7.11.1 Enabling ETH-AIS Function
To enable/disable ETH-AIS function, use the following command.
Command
Mode
Description
ethernet oam ais enable meg
NAME [mepid <1-8191>]
Global
Enables ETH-AIS function.
NAME: MEG’s name
ethernet oam ais disable meg
NAME [mepid <1-8191>]
Disables ETH-AIS function
ETH-AIS function can not be used within STP environments. ETH-AIS can be enabled
when STP is disabled in the system.
To enable/disable a transmission of frame with ETH-AIS information on a MEP, use the
following command.
Command
Mode
Description
ethernet oam ais transmit ena-
ble meg NAME [mepid <1-8191>]
Global
Enables ETH-AIS frame transmission on a MEP.
NAME: MEG’s name
ethernet oam ais transmit disa-
ble meg NAME [mepid <1-8191>]
Disables ETH-AIS frame transmission on a MEP.
To enable/disable Unicast AIS frame transmission from the configured MEPs, use the fol-
lowing command.
Command
Mode
Description
ethernet oam ais unicast enable
meg NAME mepid <1-8191>
rmac MACADDR
Global
Enables Unicast AIS frame transmission from the
MEPs.
ethernet oam ais unicast disable
meg NAME mepid <1-8191>
[rmac MACADDR]
Disables Unicast AIS frame transmission from the
MEPs.
!
ii