Dasan V8102 - Ipv6 PIM Debug

User Manual UMN:CLI
V8102
587
11.3.8 IPv6 PIM Debug
To enable IPv6 PIM-SM debugging, use the following command.
Command
Mode
Description
debug ipv6 pim sparse-mode
{all | events | nexthop | mib | mfc
| nsm | state | packet [in | out]}
Enable
Enables PIM-SM debugging.
all: all PIM-SM debugging
events: events debugging
nexthop: nexthop communications debugging
mib: MIBs debugging
mfc: MFC add/delete/update debugging
nsm: NSM communications debugging
state: debugging of state transition on all FSMs
packet: incoming and/or outgoing packets debugging
no debug ipv6 pim sparse-mode
{all | events | nexthop | mib | mfc
| nsm | state | packet [in | out]}
Disables PIM-SM debugging.
To enable IPv6 PIM-SM timer debugging, use the following command.
Command
Mode
Description
debug ipv6 pim sparse-mode
timer
Enable
Enables PIM-SM timer debugging.
debug ipv6 pim sparse-mode
timer assert [at]
Enables PIM-SM assert timer debugging.
debug ipv6 pim sparse-mode
timer bsr [bst | crp]
Enables PIM-SM BSR timer debugging.
bst: bootstrap debugging timer
crp: candidate RP debugging timer
debug ipv6 pim sparse-mode
timer hello [ht | nlt | tht]
Enables PIM-SM hello timer debugging.
ht: hello timer
nlt: neighbor liveness timer
tht: triggered hello timer
debug ipv6 pim sparse-mode
timer joinprune [jt | et | ppt | kat |
ot]
Enables PIM-SM join/prune timer debugging.
jt: join timer
et: expiry timer
ppt: prune pending timer
kat: keep alive timer
ot: override timer
debug ipv6 pim sparse-mode
timer register [rst]
Enables PIM-SM register timer debugging.
To disable IPv6 PIM-SM timer debugging, use the following command.
Command
Mode
Description
no debug ipv6 pim sparse-mode
timer
Enable
Disables PIM-SM timer debugging.
no debug ipv6 pim sparse-mode