EasyManua.ls Logo

Dasan V8102 - Interface Configuration Mode; Ethernet Interface Mode

Dasan V8102
910 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
UMN:CLI User Manual
V8102
52
3.1.4 Interface Configuration Mode
The Interface Configuration mode configures the switch at the physical interface level. In
a particular interface mode, you can use the commands configure specific IP interface
settings, including bridge-group, description, etc.
The following table shows several types of interfaces.
Interface Type
Internal i/f Name
(Abbreviation)
Configuration (CLI)
Description
gpon
GPON
SWITCH(config)# interface gpon 1/1
SWITCH(config-if[GPON1/1])#
G.984.x GPON
gigabitethernet
GE
SWITCH(config)# interface gigabitether-
net 1/1
SWITCH(config-if[GE1/1])#
Gigabit Ethernet IEEE 802.3z
tengigabitethernet
XE
SWITCH(config)# interface tengiga-
bitethernet 0/1
SWITCH(config-if[XE1/1])#
10-Gigabit Ethernet IEEE 802.3an
management
mgmt
SWITCH(config)# interface management
SWITCH(config-if[mgmt])#
Management interface
channelgroup
CG
SWITCH(config)# interface channelgroup
GROUP-ID
SWITCH(config-if[CG#])#
Link aggregation
vlan
br
SWITCH(config)# interface vlan 1
SWITCH(config-if[1])#
Virtual LAN
loopback
lo
SWITCH(config)# interface loopback
SWITCH(config-if[lo])#
Loopback interface
tunnel
tunnel
SWITCH(config)# interface tunnel 1
SWITCH(config-if[tunnel1])#
Tunnel interface
3.1.4.1 Ethernet Interface Mode
The Ethernet Interface mode contains commands for configuring the 1GE or 10GE inter-
face. You can open this Interface Configuration mode when at least one SFU_10GE4
module is installed in the V8102 chassis.
To open Ethernet Interface Configuration mode, enter the interface gigabitether-
net/tengigabitethernet command, then the system prompt will be changed from
SWITCH(config)# to SWITCH(config-if[GE])# or SWITCH(config-if[XE])#.
Command
Mode
Description
interface {gigabitethernet |
tengigabitethernet} IFPORT
Global
Enters the Interface Configuration mode to configure
an 1G/10G Ethernet type interface.
IFPORT: physical interface port number
(SLOT#/PORT#, e.g. 0/1, 0/2)
IFPORT-RANGE: list of valid ports per Ethernet inter-
interface range {gigabitethernet
| tengigabitethernet} IFPORT-
RANGE

Table of Contents