User Manual UMN:CLI
V8102
73
SWITCH(config)# privilege enable level 0 show
SWITCH(config)# privilege enable level 1 configure terminal
SWITCH(config)# show privilege
Command Privilege Level Configuration
-----------------------------------------------
Node All Level Command
EXEC(ENABLE) 1 configure terminal
EXEC(VIEW) 0 enable
EXEC(ENABLE) 0 show
3 entry(s) found.
SWITCH(config)#
In the above configuration, as level 0, it is possible to use only show command in Privi-
leged EXEC Enable mode; however as level 1, it is possible to use not only the com-
mands in level 1 but also time configuration commands in Privileged EXEC Enable mode
and accessing commands to Global Configuration mode.
4.1.3.8 Limiting Number of Users
For the V8102, you can limit the number of users accessing the switch through telnet. In
case of using the system authentication with RADIUS or TACACS+, a configured number
includes the number of users accessing the switch via the authentication server. To set
the number of users accessing the switch, use the following command.
Sets the number of users accessing the switch.
1-8: the number of user (default: 8)
Deletes a configured value.
4.1.3.9 Limiting the Number of login attempts
For security reasons of the system, administrator can configure the number of the login
attempts. To configure the system login attempts, use the following command.
login attempts <1-5> delay <5-
60>
Sets login attempts.
1-5: number of retry login attempts (default: 5)
5-60: access delay time (default: 5 minutes)
To display a configuration of login attempts function, use the following command.
show login attempts log [USER]
Shows login attempt information
To delete or reset the configured login attempts, use the following command.
To Next Page
Loading...