User Manual UMN:CLI
V8102
563
show ipv6 mld snooping explic-
it-tracking groups [{X:X::X:X |
channelgroup IFPORT | gpon
FPORT | tengigabitehternet
FPORT | vlan VLAN}]
Shows the explicit host tracking information per group.
X:X::X:X: multicast group address
Explicit host tracking is enabled by default.
11.2.3.6 Multicast Router Port Configuration
The multicast router port is the port which is directly connected to a multicast router. A
switch adds multicast router ports to the forwarding table to forward membership reports
only to those ports.
Static Multicast Router Port
You can statically configure Layer 2 port as the multicast router port which is directly con-
nected to a multicast router, allowing a static connection to a multicast router.
To specify a multicast router port, use the following command.
ipv6 mld snooping mrouter port
{PORTS | cpu}
Specifies a multicast router port.
PORTS: port number
cpu: cpu port.
To delete a specified multicast router port, use the following command.
no ipv6 mld snooping mrouter
port {PORTS | cpu}
Deletes a specified multicast router port.
Displaying Multicast Router Port
To display a current multicast router port for MLD snooping, use the following command.
show ipv6 mld snooping mrout-
er IFNAME
Shows a current multicast router port for MLD snooping
globally.
IFNAME: VLAN interface name
To Next Page
Loading...