Dasan V8102 - Tab. 7.1 ETH-CCM Interval Field Encoding

User Manual UMN:CLI
V8102
191
NAME [mepid <1-8191>]
ethernet oam cc disable meg
NAME [mepid <1-8191>]
Disables MEPs to send Continuity Check messages.
To enable/disable unicast CC transmission, use the following command.
Command
Mode
Description
ethernet oam cc unicast enable
meg NAME mepid <1-8191>
rmac MACADDR
Global
Enables unicast ETH-CC transmission in a MEG.
1-8191: MEP’s ID
MACADDR: the remote MEP’s MAC address
ethernet oam cc unicast disable
meg NAME mepid <1-8191>
[rmac MACADDR]
Disables unicast ETH-CC transmission in a MEG.
To identify the priority of frame with ETH-CC information, use the following command.
Command
Mode
Description
ethernet oam cc meg NAME
priority <0-7>
Global
Specifies a priority of CCM frames.
<0-7>: priority of CCM frames (default: 7)
no ethernet oam cc meg NAME
priority
Deletes a specified priority and returns to the default
setting.
To specify an interval for sending periodic continuity check messages, use the following
command.
Command
Mode
Description
ethernet oam cc meg NAME
interval TIME
Global
Configures the interval of CCMs.
TIME: 3.3ms, 10ms, 100ms, 1s(default), 10s, 1min,
10min
no ethernet oam cc meg NAME
interval
Deletes a specified interval and returns to the default
setting.
The following table shows CCM interval field encoding for ITU-T Y.1731 OAM.
Interval Field
Period Value
Transmission Rate
2
10 ms
100 frames per second
3
100 ms
10 frames per second (default transmission period for performance
monitoring application)
4
1 s
1 frames per second (default transmission period for fault management
application)
5
10 s
6 frames per minute
6
1 min
1 frames per minute
7
10 min
6 frames per hour
Tab. 7.1 ETH-CCM Interval Field Encoding