User Manual UMN:CLI
V8102
53
face unit. Use a hyphen to designate a range of ports.
(e.g. 0/1-4 or 0/1-0/4)
3.1.4.2 GPON Interface Mode
The GPON Interface mode contains commands for configuring the GPON interface. You
can open this Interface Configuration mode when at least one SIU_GPON16 module is
installed in the V8102 chassis.
To open GPON Interface Configuration mode, enter the interface gpon command, then
the system prompt will be changed from SWITCH(config)# to SWITCH(config-if[GPON])#.
Enters the Interface Configuration mode to configure
an GPON type interface.
IFPORT: physical interface port number
(SLOT#/PORT#, e.g. 1/1, 2/1)
IFPORT-RANGE: list of valid ports per GPON interface
unit. Use a hyphen to designate a range of ports.
(e.g. 1/1-16 or 1/1-1/16)
interface range gpon IFPORT-
RANGE
3.1.4.3 Management (MGMT) Interface Mode
You can configure the system to be accessed remotely by Telnet. Firstly, you have to in-
stall the SFU module in the central slot of the chassis. The V8102 has a management
port (MGMT) and console port on the front panel of SFU module.
To open Interface MGMT Interface Configuration mode, enter the interface management
command, then the system prompt will be changed from SWITCH(config)# to
SWITCH(config-if[mgmt])#.
Opens MGMT Interface Configuration mode to specify
an IP address.
3.1.4.4 VLAN Database Mode
To create a VLAN, the VLAN Database mode contains the commands. To open VLAN Da-
tabase mode, enter the vlan database command, then the system prompt will be
changed from SWITCH(config)# to SWITCH(config-vlan)#.
Opens VLAN Database mode.
Creates a VLAN by assigning VLAN ID:
VLANS: VLAN ID (2-4094, multiple entries possible)
To Next Page
Loading...