UMN:CLI User Manual
V8102
516
10.2.9 Multicast-Source Trust Port
Any port of V8102 can be specified as a multicast-source trust port which is registered in
the multicast forwarding table. Only multicast-source trust ports can be received the mul-
ticast traffic.
However, the reserved multicast packets should be sent to CPU even if these packets
pass through a multicast-source trust port. This feature helps the switch to distinguish be-
tween general traffic receivers and multicast traffic receivers, and is a more efficient use
of system resources because it sends the multicast traffic to specific hosts which want to
receive the traffic.
To configure a specified port as a multicast-source trust port, use the following command.
ip multicast-source trust port
PORTS
Specifies multicast-source trust ports
no ip multicast-source trust port
PORTS
Deletes the configured multicast-source trust ports
To Next Page
Loading...