Dasan V8102 - Saving Multicast ACL

User Manual UMN:CLI
V8102
887
To remove the dynamic/static access control list configuration from the multicast access
list, use the following command.
Command
Mode
Description
no igmp {access-list | static-access-list} all
Multicast-
ACL
Removes the dynamic/static access
control list configuration from the mul-
ticast access list.
no igmp access-list vid {untagged | VLANS}
dst-ip start A.B.C.D end A.B.C.D [bw VALUE |
src-ip A.B.C.D | gem PORTS]
no igmp static-access-list vid {untagged |
VLANS} dst-ip start A.B.C.D end A.B.C.D [bw
VALUE | src-ip A.B.C.D | gem PORTS]
13.11.6.3 Saving Multicast ACL
After configuring a multicast ACL, you need to save the profile using the following com-
mand.
Command
Mode
Description
apply
Multicast-
ACL
Saves a multicast ACL configuration.
Whenever you modify a multicast ACL, you should apply the changes again using the
apply command. If you do not, it will not be applied.
13.11.6.4 Applying Multicast Access List
To apply the configured multicast access list to a specified ONU ID, use the following
command.
Command
Mode
Description
onu multicast-access-list ONU-
ID NAME [multicast-profile
NAME]
Interface
[GPON]
Applies the dynamic/static multicast access control list
table to ONU ID. It discards the IGMP join message
from ONTs based on the access list.
ONU_ID: ONU ID or ONU serial number
NAME: multicast access list name
multicast-profile: applies the multicast ACL to the speci-
fied ONUs on the Multicast profile.
NAME: multicast profile name
no onu multicast-access-list
ONU-ID NAME [multicast-profile
NAME]
Removes the specified multicast access list configura-
tion from ONU ID.
Up to 8 multicast access lists can be configured per ONU ID.
i
i