Dasan V8102 - Ipv6 Access List Zebos for ICMP

UMN:CLI User Manual
V8102
258
actual value for ToS)
pkt-size: Identifies packet size.
gt: packet size less than or greater than specified val-
ue.
lt: packet size less than or greater than specified value.
(0-65535: packet size)
fragments: An ACL applies to the non-initial fragment of
packet.
log: logs the results.
interface: the name of the input or output interface.
To delete an existing ipv6 access-list (ACL) to filter packets, use the following command.
Command
Mode
Description
no ipv6 access-list zebos WORD {deny | per-
mit}
Global
Deletes an entry of the ZeBos extend-
ed ACL.
no ipv6 access-list zebos WORD {deny | per-
mit} {ip | gre | igmp | pim | rsvp | ospf | vrrp |
ipcomp | any | <0-255>} {SOUR_ADDR |
SOUR_ADDR_RANGE | any} {DES_ADDR |
DES_ADDR_RANGE | any} {label <1-65535> |
precedence <0-7> | tos {<0-255> | range <0-
255> <0-255>} | pkt-size {lt <0-65535>| gt <0-
65535> | range <0-65535> <0-65535>} | frag-
ments | log | interface {in | out} [{tengiga-
bitethernet IFPORT | gpon IFPORT | chan-
nelgroup} IFPORT | vlan VLANID}]
7.18.10.1 IPv6 Access List ZeBos for ICMP
To create an access-list (ACL) to filter packets specific to the ICMP protocol, use the fol-
lowing command.
Command
Mode
Description
ipv6 access-list zebos WORD
{deny | permit} icmp
{SOUR_ADDR |
SOUR_ADDR_RANGE | any}
{DES_ADDR |
DES_ADDR_RANGE | any}
Global
Specifies a deny or permit statement of the Zebos ex-
tanded ACL to filter packets specific to the ICMP proto-
col.
WORD: access-list name
deny: specifies route to deny.
permit: Specified route to permit.
SOUR_ADDR: source IPv6 address to match
(X:X::X:X/M)
SOUR_ADDR_RANGE: source IPv6 address range to
match (X:X::X:X X:X::X:X)
DES_ADDR: destination IPv6 address to match
(X:X::X:X/M)
DES_ADDR_RANGE: destination IPv6 address range
to match (X:X::X:X X:X::X:X)
ipv6 access-list zebos WORD
{deny | permit} icmp
{SOUR_ADDR |
SOUR_ADDR_RANGE | any}
{DES_ADDR |
DES_ADDR_RANGE | any}
[{icmp-type ICMP-TYPE | label
<1-65535> | precedence <0-7> |