Dasan V8102 - VRRP Debug; Rate Limit

UMN:CLI User Manual
V8102
460
9.9.3.3 VRRP Debug
To enable VRRP debugging, use the following command.
Command
Mode
Description
debug vrrp [all]
Enable
Enables VRRP debugging.
all: all VRRP debugging
debug vrrp nsm [interface | bfd |
efm]
Enables VRRP debugging.
nsm: NSM notifications debugging
interface: interface information
bfd: BFD detection
efm: EFM-OAM detection
debug vrrp packet [send | recv |
detail]
Enables VRRPv2 packets debugging.
packet: VRRPv2 packets
send: outgoing packets
recv: incoming packets
detail: detail information
debug vrrp sm [events | status |
timers]
Enables VRRP state machine debugging.
sm: state machine
events: SM events
status: SM status
timers: SM timers
To disable VRRP debugging, use the following command.
Command
Mode
Description
no debug vrrp [all]
Enable
Disables VRRP debugging.
no debug vrrp nsm [interface | bfd]
no debug vrrp packet [send | recv | detail]
no debug vrrp sm [events | status | timers]
To display the debugging information, use the following command.
Command
Mode
Description
show debugging vrrp
Enable
Global
VRRP
Shows the debugging information of VRRP.
9.10 Rate Limit
User can customize port bandwidth according to user’s environment. By this configuration,
you can prevent a certain port to monopolize whole bandwidth so that all ports can use
bandwidth equally. Egress and ingress can be configured both to be same and to be dif-
ferent.