Dasan V8102 - Page 151

User Manual UMN:CLI
V8102
151
user. When port traffic falls below the threshold, trap message will be shown.
• temp-threshold is shown when the system temperature exceeds the thresh-old con-
figured by user. when system temperature falls below the threshold, trap message
will be shown.
• dhcp-lease is shown when no more IP address is left in the DHCP pool. Even if this
occurs only in one DHCP pool of several pools, this trap message will be shown.
• fan/power/module is shown when there is any status-change of fan, power, and
module.
The system is configured to send all the SNMP traps by default.
To enable the SNMP trap, use the following command.
Command
Mode
Description
snmp trap auth-fail
Global
Configures the system to send SNMP trap when SNMP
authentication is fail.
snmp trap cli-history
Configures the system to send SNMP trap of CLI histo-
ry log.
snmp trap cold-start
Configures the system to send SNMP trap when SNMP
agent restarts.
snmp trap cpu-threshold [iu
SLOTS]
Configures the system to send SNMP trap when CPU
load exceeds or falls below the threshold.
snmp trap dhcp-lease
Configures the system to send SNMP trap when no
more IP address is left in the DHCP pool.
snmp trap detect-rogue-onu
IFPORT
Configures the system to send SNMP trap
snmp trap onu-broadcast-storm
Configures the system to send SNMP trap when ONU
broadcast storm controls.
snmp trap onu-crc-error
Configures the system to send SNMP trap when ONU
cre occurs errors.
snmp trap onu-line-code-error
Configures the system to send SNMP trap when ONU
line code occurs errors.
snmp trap fan
Configures the system to send SNMP trap when the
fan begins to operate or stops.
snmp trap system-restart
Configures the system to send SNMP trap when sys-
tem restarts.
snmp trap link-threshold
Configures the system to send SNMP trap when inter-
face link exceeds or falls below the threshold.
snmp trap linkstatus
Configures the system to send SNMP trap when there
is any problem in link.
snmp trap mem-threshold
Configures the system to send SNMP trap when
memory usage exceeds or falls below the threshold.
snmp trap module
Configures the system to send SNMP trap when there
is any problem in module.
snmp trap power
Configures the system to send SNMP trap when any
problem occurs in power.
i