Dasan V8102 - Page 16

UMN:CLI User Manual
V8102
16
5.5.3 Tunnel Address Configuration .................................................................... 94
5.5.4 Tunnel Encapsulation Mode ....................................................................... 95
5.6 Assigning IP Address .......................................................................... 96
5.6.1 Enabling MGMT/VLAN Interface ................................................................ 96
5.6.2 Assigning IP Address to Network Interface ................................................ 96
5.6.3 Assigning IPv6 Address ............................................................................. 98
5.6.3.1 Assigning IPv6 Address to Network Interface .............................................. 100
5.6.3.2 Assigning Link Local Address to Network Interface ..................................... 101
5.6.3.3 Static Route and Default Gateway ............................................................... 102
5.6.3.4 Enabling IPv6 Processing ............................................................................ 103
5.6.3.5 IPv6 Interface Mode ..................................................................................... 103
5.6.3.6 Displaying IPv6 interface ............................................................................. 104
5.6.3.7 IPv6 PBR Configuration ............................................................................... 104
5.6.4 Static Route and Default Gateway ........................................................... 105
5.6.5 Displaying IP Address Assignment .......................................................... 106
5.6.6 Initial Management Access and IP Address Assignment ......................... 106
5.7 SFU Redundancy .............................................................................. 108
5.7.1 Automatic Switchover ............................................................................... 108
5.7.2 Fault Monitoring Function......................................................................... 109
5.7.3 Data Synchronization between SFUs ....................................................... 110
5.8 Configure External Alarm LEDs .......................................................... 111
5.9 IU Firmware Upgrade ........................................................................ 113
5.9.1 Manually Upgrading SFU .......................................................................... 113
5.9.2 Upgrading IUs ........................................................................................... 113
5.9.3 Manually SFU Firmware Uploading .......................................................... 114
5.10 Ethernet Port Configuration ............................................................... 115
5.10.1 Enabling Ethernet Port .............................................................................. 115
5.10.2 Auto-Negotiation ....................................................................................... 115
5.10.3 Transmit Rate ............................................................................................ 116
5.10.4 Duplex Mode ............................................................................................. 116
5.10.5 Link Monitoring Timer ................................................................................ 116
5.10.6 Network Service Port ................................................................................ 117
5.10.7 L2 Port Bridge ........................................................................................... 117
5.10.8 Port Crossover .......................................................................................... 117
5.10.9 Flow Control .............................................................................................. 118
6 System Environment ...................................................................... 119
6.1 Environment Configuration ................................................................ 119
6.1.1 Terminal Configuration .............................................................................. 119
6.1.2 Fan Operation ........................................................................................... 119
6.1.3 Disabling Daemon Operation .................................................................... 119
6.1.4 FTP Bind Address .................................................................................... 120
6.1.5 Enable DDM Function .............................................................................. 120
6.1.5.1 SFP Module Operation ................................................................................ 121
6.1.6 System Threshold .................................................................................... 122
6.1.6.1 CPU Load .................................................................................................... 122
6.1.6.2 Port Traffic ................................................................................................... 123
6.1.6.3 Fan Operation .............................................................................................. 123
6.1.6.4 System Temperature .................................................................................... 124
6.1.6.5 System Memory ........................................................................................... 125