User Manual UMN:CLI
V8102
173
| notice | info} remote A.B.C.D
no syslog output priority {auth |
authpriv | kern | local0 | local1 |
local2 | local3 | local4 | local5 |
local6 | local7 | syslog | user}
{emerg | alert | crit | err | warning
| notice | info} external sdcard
{sfu | slot SLOT_NUMBER}
The order of priority is emergency > alert > critical > error > warning > notice > info >
debug. If you set a specific level of syslog output, you will receive only a syslog message
for selected level or higher. If you want receive a syslog message for all the levels, you
need to set the level to debug.
The following is an example of configuring syslog message to send all logs higher than
notice to remote host 10.1.1.1 and configuring local1.info to transmit to console.
SWITCH(config)# syslog output notice remote 10.1.1.1
SWITCH(config)# syslog output priority local1 info console
SWITCH(config)# show syslog
System logger on running!
info local volatile
info local non-volatile
notice remote 10.1.1.1
local1.info console
SWITCH(config)#
Syslog Output Level on the SD card
If the SD card is mounted in the V8102 chassis, you can save the syslog logs to the SD
card instead of local/remote memory. To store a system logs on the SD card and set its
syslog output level, use the following command.
syslog output {emerg | alert | crit
| err | warning | notice | info |
debug} external sdcard sfu
Generates a syslog message of selected level or high-
er and forwards it to a SD card.
syslog output {emerg | alert | crit
| err | warning | notice | info |
debug} external sdcard slot
SLOT_NUMBER
no syslog output {emerg | alert |
crit | err | warning | notice | info |
debug} external sdcard {sfu |
slot SLOT_NUMBER}
Deletes a specified user-defined syslog message.
To Next Page
Loading...