Dasan V8102 - Page 240

UMN:CLI User Manual
V8102
240
Add entries to the list by repeating the command for different IP addresses.
To delete an existing extended IP address-based access list entry, use the following
command.
Command
Mode
Description
no access-list {<100-199> | <2000-2699>} {deny |
permit} ip A.B.C.D WILDCARD-BITS A.B.C.D
WILDCARD-BITS
Global
Deletes an entry of the extended ACL.
no access-list {<100-199> | <2000-2699>} {deny |
permit} ip host A.B.C.D A.B.C.D WILDCARD-
BITS
no access-list {<100-199> | <2000-2699>} {deny |
permit} ip host A.B.C.D any
no access-list {<100-199> | <2000-2699>} {deny |
permit} ip host A.B.C.D host A.B.C.D
no access-list {<100-199> | <2000-2699>} {deny |
permit} ip any A.B.C.D A.B.C.D WILDCARD-BITS
no access-list {<100-199> | <2000-2699>} {deny |
permit} ip any any
no access-list {<100-199> | <2000-2699>} {deny |
permit} ip any host A.B.C.D
no access-list {<100-199> | <2000-2699>} re-
mark LINE
Sample Configuration
This is an example of creating the extended ACL entries.
SWITCH(config)# access-list 100 permit ip 10.55.10.2 0.0.0.255 10.55.193.5
0.0.0.255
SWITCH(config)# access-list 100 deny ip 10.12.154.1 0.0.0.255 10.12.202.1
0.0.0.255
SWITCH(config)#
i