Dasan V8102 - Page 246

UMN:CLI User Manual
V8102
246
solicitation | source-quench | source-route-
failed | time-exceeded | timestamp-reply |
timestamp-request | traceroute | ttl-exceeded |
unreachable }] [{precedence <0-7> | tos <0-
255> | dscp <0-63>}] [{ log | log-input} tag
WORD ]
[<1-2147483647>] { deny | permit } tcp {any |
host A.B.C.D | A.B.C.D WILDCARD-BITS} {any |
eq PORT | gt PORT | lt PORT | neq PORT |
range RANGE } {any | host A.B.C.D | A.B.C.D
WILDCARD-BITS} {any | eq PORT | gt PORT | lt
PORT | neq PORT | range RANGE }
[{TCP_FLAG | precedence <0-7> | tos <0-255> |
dscp <0-63>}] [{ log | log-input} tag WORD ]
Specifies a deny or permit statement of
the extended ACL based on TCP.
eq: match only packets on a given port
number
gt: match only packets with a greater port
number
lt: match only packets with a lower port
number
neq: match only packets not on a given
port number
range: match only packets in the range of
port numbers
[<1-2147483647>] { deny | permit } udp {any |
host A.B.C.D | A.B.C.D WILDCARD-BITS} {any |
eq PORT | gt PORT | lt PORT | neq PORT |
range RANGE } {any | host A.B.C.D | A.B.C.D
WILDCARD-BITS} {any | eq PORT | gt PORT | lt
PORT | neq PORT | range RANGE } [{prece-
dence <0-7> | tos <0-255> | dscp <0-63>}] [{ log
| log-input} tag WORD ]
Specifies a deny or permit statement of
the extended ACL based on UDP.
eq: match only packets on a given port
number
gt: match only packets with a greater port
number
lt: match only packets with a lower port
number
neq: match only packets not on a given
port number
range: match only packets in the range of
port numbers
[<1-2147483647>] { deny | permit } igmp {any |
host A.B.C.D | A.B.C.D WILDCARD-BITS} {any |
host A.B.C.D | A.B.C.D WILDCARD-BITS}
[{dvmrp | host-query | host-report | pim | trace}]
[{precedence <0-7> | tos <0-255> | dscp <0-
63>}] [{ log | log-input} tag WORD ]
Specifies a deny or permit statement of
the extended ACL based on IGMP.
remark LINE
Writes comments for this access-list.
LINE: access list entry comments up to
100 characters
To delete the configured extended ACL entry, use the following command.
Command
Mode
Description
no <1-2147483647>
Extended
ACL Mode
Deletes an entry of the ex-
tended ACL.
no { deny | permit } {<0-255> | ahp | eigrp | esp | gre | ip |
ipinip | nos | ospf | pcp | pim } {any | host A.B.C.D | A.B.C.D
WILDCARD-BITS} {any | host A.B.C.D | A.B.C.D WILDCARD-
BITS} [{ precedence <0-7> | tos <0-255> | dscp <0-63>}]