Dasan V8102 - Page 248

UMN:CLI User Manual
V8102
248
After creating a standard MAC address-based ACL entry, the prompt changes from
SWITCH(config)# to SWITCH(config-ext-macl])#.
To configure an extended MAC address-based ACL entry, use the following command.
Command
Mode
Description
[<1-2147483647>] { deny | permit }
{any | host HOST-MACADDR |
MACADDR MACADDR-MASK } {any
| host HOST-MACADDR | MACADDR
MACADDR-MASK} {TYPE-NUM |
aarp | amber | any | dec-spanning |
decnet-iv | diagnostic | dsm | etype-
6000 | etype-8042 | lat | lavc-sca |
mop-console | mop-dump | msdos |
mumps | netbios | vines-echo |
vines-ip | xns-idp } cos {<0-7> | any}
MAC
ACL
Mode
Specifies a deny or permit statement of the MAC ad-
dress-based ACL.
1-2147483647: sequence number
any: any source/destination MAC address
host: A single source/destination MAC
HOST-MACADDR: host MAC address
MACADDR: source/destination MAC address
MACADDR-MASK: source/destination MAC address
mask
TYPE-NUM: Ethernet type (ex: 0x0800 for IPv4)
remark LINE
Writes comments for this MAC address-based ACL.
LINE: access list entry comments up to 100 characters
no <1-2147483647>
Deletes an entry of the MAC address-based ACL.
no {deny | permit} {any | host HOST-
MACADDR | MACADDR MACADDR-
MASK } {any | host HOST-
MACADDR | MACADDR MACADDR-
MASK} {TYPE-NUM | aarp | amber |
any | dec-spanning | decnet-iv |
diagnostic | dsm | etype-6000 |
etype-8042 | lat | lavc-sca | mop-
console | mop-dump | msdos |
mumps | netbios | vines-echo |
vines-ip | xns-idp } cos {<0-7> | any}
no remark LINE
To display the configured extended MAC address-based ACL, use the following command.
Command
Mode
Description
show mac access-list {<700-799> |
<1100-1199> | WORD}
Global
Shows the configured extended MAC address-based
ACL.
700-799: extended MAC access-list number
1100-1199: extended MAC access-list number (ex-
panded range)
WORD: access list name