EasyManua.ls Logo

Dasan V8102 - Page 466

Dasan V8102
910 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
UMN:CLI User Manual
V8102
466
slow down or to time out. The V8102 provides the attack guard function that controls traf-
fic for a specified port by threshold value. The threshold (%) rate of attack guard is based
on the number of packets per second (pps) that is calculated by 64-byte frame size. If the
number of incoming packets exceeds a given threshold, the system can shut down the
port or generate SNMP trap messages for warning when attack guard function is enabled
on this port. If the threshold (%) comes down to a given low threshold, it generates traps.
You can specify the packet type, a high threshold value and a low threshold for a port.
To enable/disable the attack guard function, use the following command.
Command
Mode
Description
attack-guard {broadcast |
multicast | unicast} <0-100>
<0-100> [PORTS]
Interface
[XE/GE/GPON/CG]
Enables the attack guard function according to its
packet type and sets the threshold.
PORTS: port number
0-100: high rate threshold percent (default: 80%)
0-100: low rate threshold percent (default: 20%)
no attack-guard {broadcast |
multicast | unicast} [PORTS]
Disable the attack guard function.
If the high threshold is set to 85% for 1G Ethernet port, the V8102 monitors the number of
configured packet type. The number of those packets exceeds 1,264,880 pps
(=14,880,95 * 0.85), the shutdown/trap action will be performed.
To determine the policy to take action when the incoming broadcast/multicast/unicast
packets exceed the configured threshold, use the following command.
Command
Mode
Description
attack-guard action shutdown
[PORTS]
Interface
[XE/GE/GPON/CG]
Shuts down the port if the amount of traffic ex-
ceeds a high threshold.
attack-guard action trap
[PORTS]
Generates a trap message when the amount of
traffic exceeds a high threshold.
no attack-guard action {shut-
down | trap } [PORTS]
Disables the shutdown action or trap action on a
port when the attack guard function is enabled.
To display the attack guard configuration, use the following command.
Command
Mode
Description
show attack-guard
Enable
Interface
[XE/GE/GPON/CG]
Displays the attack guard configuration.
i

Table of Contents