User Manual UMN:CLI
V8102
541
no ip igmp ssm-map enable
Disables SSM mapping for groups.
To configure the switch to statically map groups that match specified ACL to source ad-
dress, use the following command.
ip igmp ssm-map static {<1-99> |
<1300-1999> | WORD} A.B.C.D
Enables a static SSM mapping for the group that
matches specified ACL and source address.
1-99: standard access list number
1300-1999: extended range of standard access list
WORD: IP named standard access list
A.B.C.D: source address to use for static map group
no ip igmp ssm-map static {<1-
99> | <1300-1999> | WORD}
A.B.C.D
Disables a static SSM mapping for the group that
matches specified ACL and source address.
To display the sources that SSM mapping uses for a particular group, use the following
command.
show ip igmp ssm-map [A.B.C.D]
Shows a static SSM mapping information
A.B.C.D: multicast group address
To Next Page
Loading...