UMN:CLI User Manual
V8102
592
network. If you do use neither ge nor le, network range is more clearly configured. When
only ge attribute is configured, network range is configured from ge value, and when only
le attribute is configured, network range is configured from netmask to le value.
To delete the configured policy of prefix list, use the following command.
no ipv6 prefix-list WORD seq <1-4294967295>
{deny | permit} { X:X::X:X/M | any}
Deletes the entry in an IPv6 prefix list
and removes a sequence number from
the entry.
no ipv6 prefix-list WORD seq <1-4294967295>
{deny | permit} X:X::X:X/M ge <0-32> [le <0-32>]
no ipv6 prefix-list WORD seq <1-4294967295>
{deny | permit} X:X::X:X/M le <0-32> [ge <0-32>]
With sequenced prefix lists, each prefix list entry is associated with a sequence number.
Sequence numbers can be used to insert a prefix list into the middle of an existing list or
to delete an existing statement in the list.
To include the sequence numbers in the configuration, use the following command.
ipv6 prefix-list sequence-number
Includes sequence numbers in non-
volatile generation (NVGEN).
To exclude the sequence numbers, use the following command.
no ipv6 prefix-list sequence-number
Excludes sequence numbers in non-
volatile generation (NVGEN).
11.3.10.3 Displaying Prefix List Entries
To display the information about a prefix list or prefix list entries, use the following com-
mand.
show ipv6 prefix-list [WORD]
Shows information about all prefix lists.
show ipv6 prefix-list WORD
X:X::X:X/M [first-match | longer]
Shows the prefix list entry according to the parameter.
longer: all entries of a prefix list that are more specific
than the given network and length
first-match: the entry of a prefix list that matches the
given prefix
show ipv6 prefix-list WORD seq
<1-4294967295>
Shows the prefix list entry with a given sequence
number.
show ipv6 prefix-list {detail |
summary} [WORD]
Shows a table showing the entries in a prefix list iden-
tified by name.
To Next Page
Loading...