UMN:CLI User Manual
V8102
60
The following is an example of displaying the list of available commands of Privileged
EXEC Enable mode.
SWITCH# show list
clear arp
clear arp IFNAME
clear ip arp inspection log
clear ip arp inspection statistics (vlan VLAN_NAME|)
clear ip bgp *
clear ip bgp * in
clear ip bgp * in prefix-filter
clear ip bgp * ipv4 (unicast|multicast) in
clear ip bgp * ipv4 (unicast|multicast) in prefix-filter
clear ip bgp * ipv4 (unicast|multicast) out
clear ip bgp * ipv4 (unicast|multicast) soft
clear ip bgp * ipv4 (unicast|multicast) soft in
clear ip bgp * ipv4 (unicast|multicast) soft out
clear ip bgp * out
clear ip bgp * soft
clear ip bgp * soft in
clear ip bgp * soft out
clear ip bgp * vpnv4 unicast in
clear ip bgp * vpnv4 unicast out
clear ip bgp * vpnv4 unicast soft
clear ip bgp * vpnv4 unicast soft in
clear ip bgp * vpnv4 unicast soft out
clear ip bgp <1-65535>
clear ip bgp <1-65535> in
clear ip bgp <1-65535> in prefix-filter
-- more --
Press the <ENTER> key to skip to the next list.
In case that the V8102 installed command shell, you can find out commands starting with
a specific alphabet. Input the first letter and question mark without space. The following is
an example of finding out the commands starting “s” in Privileged EXEC Enable mode of
the V8102.
SWITCH# s?
show Show running system information
ssh Configure secure shell
SWITCH# s
In addition, it is possible to view variables you should input following commands. After in-
putting the command you need, make one space and input a question mark. The follow-
ing is an example of viewing variables after the write command. Please note that you
must input one space between the command and question mark.
SWITCH# write ?
memory Write to NV memory
terminal Write to terminal
SWITCH# write
To Next Page
Loading...