UMN:CLI User Manual
V8102
608
It’s the waiting time for the restarting of Neighboring router’s BGP process. Restart
time allows BGP process time to restart and implement the internal connection (The
session). However, if it’s not working properly, it is considered as the router stops op-
erating.
• Stalepath Time
After BGP process of Neighboring router is restarted, it holds the time until BGP up
dates the path information. In case that the information of BGP routes is not updated
until the stalepath time, the switch discards this BGP routes information.
To set restart time or stalepath time on Graceful Restarting algorithm, use the following
command.
bgp graceful-restart restart-time
<1-3600>
Sets the restart time of Graceful Restart configuration
in the unit of second.
1-3600: restart time (default: 120)
bgp graceful-restart stalepath-
time <1-3600>
Sets the stalepath-time of Graceful Restart configura-
tion in the unit of second.
1-3600: stalepath time (default: 30)
If you don’t use Graceful Restart feature or want to return the default value for restart time
or stalepath time, use the following command.
no bgp graceful-restart restart-
time [<1-3600>]
Restores the default value for restart time.
no bgp graceful-restart
stalepath-time [<1-3600>]
Restores the default value for stalepath time.
You can restart configured graceful for BGP, OSPF and RIP in Privileged EXEC Enable
mode, use the following command.
Restarts the configured BGP graceful.
restart ospf graceful [grace-
period <1-1800>]
Restarts the configured OSPF graceful in the unit of
second.
1-1800: grace-period (unit: seconds)
restart ipv6 ospf graceful [grace-
period <1-1800>]
Restarts the configured IPv6 OSPF graceful in the unit
of second.
1-1800: grace-period (unit: seconds)
restart rip graceful [grace-period
<1-65535>]
Restarts the configured RIP graceful in the unit of sec-
ond.
1-65535: grace-period (unit: seconds)
To Next Page