User Manual UMN:CLI
V8102
735
Basic Operation
• Configure OLT and ONU (ONT) in GPON Interface Configuration mode.
• For common ONU (ONT) configuration, create a profile in ONU Profile Configuration
mode.
• If the created profile is modified, the profile will be applied to the ONUs (ONTs) auto-
matically.
Specifying OLT ID and ONU ID
When specifying an OLT ID in the CLI, you can simply put the number in the form of
SLOT/PORT such as 1/1, 1/2, 1/3, 1/4, 1/5, …2/15, 2/16. Multiple input is also possible,
e.g. 2/1, 2/2, 2/3 or 2/1-2/4.
When specifying an ONU ID, just remember that the ONU ID is always between 0 and
127 or ONU serial number. Multiple input for the ONU ID is the same as the ONU ID, e.g.
1-3, 8-22, DSNWcb00282d.
CLI Structure
To configure GPON functionalities, enter the interface gpon OLT-ID command in Global
Configuration mode. The GPON Interface Configuration mode is a stage of preparation
for the detail PON configuration.
To open GPON Interface mode, use the following command.
Opens GPON Interface mode.
To Next Page
Loading...