Dasan V8102 - Page 737

User Manual UMN:CLI
V8102
737
onu encryption ONU-ID disable
Disables the encryption mode.
To start/stop an encryption key exchange process between OLT and ONU (ONT) and
specify an interval of key exchange, use the following command.
Command
Mode
Description
olt key-exchange start <10-
86400>
Interface
[GPON]
Starts an encryption key exchange process between
OLT and ONU and specifies an exchange interval.
10-86400: interval for encryption key switchover
olt key-exchange stop
Stops periodic process of encryption key exchange.
To display the status of encryption mode or information of the encryption key exchange
process, use the following command.
Command
Mode
Description
show onu encryption gpon OLT-
ID
Enable
Global
Shows the status of encryption mode.
ONU-ID: ONU ID (1 to 128) or ONU serial number
show onu encryption [ONU-ID]
Interface
[GPON]
show olt key-exchange [gpon
OLT-ID]
Enable
Global
Shows the configured interval and the encryption key
exchange process information.
show olt key-exchange
Interface
[GPON]
13.1.4 OLT Bandwidth
13.1.4.1 Upstream Bandwidth
To set the total amount of bandwidth in use for upstream traffic, use the following com-
mand.
Command
Mode
Description
olt total upstream-bw <1031616-
1244160>
Interface
[GPON]
Sets the total amount of bandwidth in use for upstream
traffic.
1031616-1244160: total upstream bandwidth (default:
1120000kbps)
no olt total upstream-bw
Deleted the configured total amount of bandwidth in
use for upstream traffic.
To display the information of OLT’s total upstream bandwidth, use the following command.
Command
Mode
Description
show olt total upstream-bw
gpon OLT-ID
Enable
Global
Shows the total upstream bandwidth of OLT