Dasan V8102 - Page 741

User Manual UMN:CLI
V8102
741
13.1.10 OLT Transceiver Configuration
To change active GPON port of OLT manually, use the following command.
Command
Mode
Description
olt transceiver port { a | b }
Interface
[GPON]
Specifies active GPON port. (default: A)
To enable/disable GPON port redundancy, use the following command.
Command
Mode
Description
olt transceiver redundancy
{enable | disable}
Interface
[GPON]
Enables/disables GPON port type A redundancy. (de-
fault: enable)
To configure a transceiver type of OLT, use the following command.
Command
Mode
Description
olt transceiver-type {fujitsu |
neophotonics | neophotonics-a |
hisense | optowiz | superxon |
wtd | sourcephotonics}
Interface
[GPON]
Configures the transceiver type of OLT port.
To display GPON port information, use the following command.
Command
Mode
Description
show olt transceiver
Enable
Global
Interface
[GPON]
Shows GPON TX port information.
show olt transceiver-type
show olt transceiver-type gpon
IFPORT