Dasan V8102 - Page 756

UMN:CLI User Manual
V8102
756
13.1.23 OMCI MIB Upload Suppression
To reduce the number of OMCI MIB upload by using the Reference DB, use the following
command.
Command
Mode
Description
olt omci-mib-upload-sup enable
Interface
[GPON]
Enables the OMCI DB check function.
olt omci-mib-upload-sup disable
Disables the OMCI DB check function.
13.1.24 PLOAM Message
To send a physical layer OAM (PLOAM) message to a specific ONU ID for debugging,
use the following command.
Command
Mode
Description
olt specific-ploam ONU-ID
MSG_ID DATA
Interface
[GPON]
Sends the PLOAM message to a specific ONU ID for
ONU-ID: ONU ID number used in PLOAM messages
(1-255)
MSG_ID: Downstream PLOAM message ID value or
private PLOAM ID defined by the G.984.3 (1-255)
DATA: 10 bytes HEX
olt specific-ploam ONU-ID reset
Sends the reset PLOAM message to a specific ONU
ID.
13.1.25 Flow Control Configuration
To configure the flow control on GPON port, use the following command.
Command
Mode
Description
olt flow-control ds enable
Interface
[GPON]
Enables the flow-control on the gpon interface.
olt flow-control ds disable
Disables the flow-control on the gpon interface.
To display the flow control, use the following command.
Command
Mode
Description
show olt flow-control [gpon
IFPORT]
Global
Interface
[GPON]
Shows the flow control information.
13.1.26 Displaying OLT Information
To display GPON OLT information, use the following command.
Command
Mode
Description
show olt status [gpon OLT-ID]
Enable
Global
Shows the information of active/inactive GPON OLT
IDs.