Dasan V8102 - Page 796

UMN:CLI User Manual
V8102
796
Command
Mode
Description
onu-profile NAME create
Global
Creates an ONU profile.
NAME: ONU profile name
Step 2 To enable GSP function, use the following command.
Command
Mode
Description
gsp {disable | enable}
ONU-
Profile
Enables generic status portal. (default:
disable)
gsp avc-report {enable
{|10min|sec}|disable}
Configures the rate of AVC report.
10min: ONU issues one AVC report to the
OLT per 10 minutes
sec: ONU issues one AVC report to the OLT
per seconds
enable: Whenever the information changes,
ONU generates AVC report. (Not
recommended.)
disable: Not generating the report to the OLT
Step 3 To apply the ONU profile to connected ONUs use the following command.
Command
Mode
Description
onu-profile ONU-IDs NAME
Interface
[GPON]
Applies an ONU profile to specified ONUs.
ONU-IDs: ONU ID (1 to 128) or ONU serial
number
NAME: ONU profile name
Step 4 To update GSP information, use the following command.
Command
Mode
Description
onu gsp update {status |
config} ONU_ID
Interface
[GPON]
Updates GSP.
ONU_ID: ONU ID (1 to128) or ONU serial
number
In case of enable status, whenever the information in the table changes, GSP will be
automatically updated according to Step 2 avc-report rate settings.
Step 5 To display a current configured GSP information, use the following command.
Command
Mode
Description
show onu gsp {config | status}
ONU_ID
Interface
[GPON]
Shows the configured GSP information.
config: configuration document table
status: status document table
ONU_ID: ONU ID (1 to128) or ONU serial
show onu gsp {status | config}
ONU_ID tag TAG_NAME
i